Martin JEM ZR44 HI-MASS Manuale Utente

user manual P/N 35010035 - C

10 Quick Start Quick Start You are no doubt eager to switch on the machine and try it out by making a lot of haze. This section tells you how to do

Installation and setting up 11 Installation and setting up DANGER! DO NOT operate the haze machine until you have read and observed all the prec

12 Installation and setting up Setting up Fill the fluid tank only with Martin R365 Haze Fluid™ (see page 21). Connect the gas line from the CO2

Installation and setting up 13 If the display shows /&&, press the RUN button to the right of the display to enable the machine. Turning

14 Control settings Control settings Overview The four quick access buttons to the left and right of the digital display at the rear of the unit al

Control settings 15 Setting Run mode The Run mode sets the operational mode of the unit, either Off, Standby (heaters remain on), Fan only, Timer m

16 Control settings Setting the DMX base address Use the Previous / Next buttons to select the !$$1 option. Use the Up/Down buttons to set the DMX b

Control settings 17 If the machine is not up to operating temperature the Prime function will do nothing. Resetting options to factory settings T

18 Remote control Remote control Overview The Jem digital remote control, available separately, may be used for remote control of the Jem Ready 365™

DMX control 19 DMX control Overview DMX is a digital control system widely used in entertainment and architectural lighting. Any controller meeti

2 Dimensions Dimensions All dimensions are in millimeters ©2013 Martin Professional A/S. Information subject to change witho

20 DMX control The functions of each DMX control channel are as follows: Channel 1 DMX value range Function Macro description Default value 0-1

Haze fluid types 21 Haze fluid types The Jem Ready 365™ must only be used with R365 Haze Fluid™. Martin supplies high quality haze fluids that ar

22 Basic service Basic service Before servicing the Jem Ready 365™, read and observe all the precautions listed in “Safety information” on page 5.

Troubleshooting 23 Troubleshooting Problem Probable cause(s) Suggested remedy Machine not at operating temperature Wait until (%!4 message no lo

24 Status messages Status messages message reason /&&The heaters are Off, the unit is shut down. (%!4The unit is heating up to operating

Specifications 25 Specifications Physical Length ...

26 Specifications Approvals European EMC:... EN 61000-6-3:2001 European saf

Specifications 27 Should you wish to use a regulator other than the Martin-approved units above, please ensure that the regulator adheres to the f

28 Specifications

Specifications 29 Disposing of this productMartin™ products are supplied in compliance with Directive 2002/96/EC of t

Contents 3 Contents Dimensions...

Martin Professional A/S,Olof Palmes Allé 18, DK-8200,Aarhus N Phone: +45 87 40 00 00 Internet: www.martin.com

4 Contents

Safety information 5 Safety information The following symbols are used to identify important safety information: Caution! Safety hazard.

6 Safety information • Do not remove the covers or attempt to repair a faulty machine. Refer any service not described in this manual to Martin. •

Safety information 7 Preventing breathing problems • A haze machine can operate safely only with the haze fluid it is designed for. Use the mach

8 Product overview Product overview Product description The Jem Ready 365™ is a versatile haze machine from Martin Professional designed for the hig

Product overview 9 Product details Digital control panel Warning, high temperature vapour and surfaces! Po