Martin RoboColor III Specifiche Scaricare il pdf (Pagina 3)

HOW TO INSTALL THE ROBOCOLOR II SYSTEM

Basically, a 'RoboColor II System' consists of two different types of components: The

'RoboColor II' units and the 'RoboColor II Controller'. The RoboColor II units are the color-

changing spotlights and the RoboColor II Controller is the "driver" for these spotlights.

You can connect either Two or Four RoboColor II units on one RoboColor II Controller.

WARNING

Do not attempt to operate the RoboColor II units without the RoboColor II Controller

(e.g. plugging the RoboColor II directly into the mains outlet)

as damage might occur to the units.

IMPORTANT

Before attempting any of the following please ensure that the units are

disconnected from any AC power.

_ Remove the 2 finger screws on the top-cover of each RoboColor II unit and carefully

remove the covers. The lamps can now be installed.

_ Replace the top-covers and tighten the screws. You can now install the RoboColor II

units in the desired positions. You are allowed to tilt the units ± 90 degree from hori-

zontal position. Do not turn the units upside down.

_ Plug the RoboColor II power cables into the RoboColor II Controller. If the RoboColor II

Controller is a 220V model there must be at least 2 RoboColor II units plugged in posi-

tion 1 and 2 or 3 and 4 (the lamps are series connected).

_ Plug the RoboColor II signal cables into the RoboColor II Controller (5 pin DIN plug).

Lengthening these cables or using extension cables is not recommended.

_ Connect the RoboColor II Controller to the mains outlet but do not switch on before

you have set the DIP switch to the desired setting as described in the following chap-

ters.

Note: It is not recommended to pair used lamps together with new ones or to pair lamps

from different manufacturers as electrical variations might shorten the lamp life.

1 2 3 4 5 6

Nessun commento

Martin RoboColor III Specifiche Pagina 3